General Category > WarmVerb Multi-FX

Using warmverb as a Send !

(1/1)

abdull:
Hello everyone

I'm trying to use warmverb as a "Send" in fl studio

But it does not work like other reverb plugins Which has wet/dry knob...


Is there a way to solve this problem?

GeorgeZ:
Hi there. To use it as a send you want a totally wet signal. Put it in your send channel. Turn up the FX mix (to taste) in each FX slot used in Warmverb and then turn up the mix knob (top right of Warmverb gui). After that just set your mix level in FL and you're away... unless I'm misunderstanding you or missing something!?

abdull:
Yes, this is the problem

When i put Warmverb in send channel, the sound level rises , so i have to adjust sound levels in each element all over again!


For example, ArtsAcoustic Reverb When I used it as a send, it raise the sound

But when i turn the dry knob down, it Sound right!. i do not have to adjust Anything!

Examigan:

--- Quote from: abdull on September 17, 2013, 09:30:56 PM ---Yes, this is the problem

When i put Warmverb in send channel, the sound level rises , so i have to adjust sound levels in each element all over again!


For example, ArtsAcoustic Reverb When I used it as a send, it raise the sound

But when i turn the dry knob down, it Sound right!. i do not have to adjust Anything!

--- End quote ---

To me, (I just tried it in Sonar to see the levels using Warmverb on a send) it seems normal since with adding an effect, it is adding more on to the sound that is already there, so the level rises a bit.
Or maybe I am way off   :o

Navigation

[0] Message Index