Tone2 support forum

General Category => Icarus => Topic started by: Burkuagh on June 07, 2017, 10:40:06 AM

Title: SuperSaw Unison Mode
Post by: Burkuagh on June 07, 2017, 10:40:06 AM

Is the SuperSaw Unison Mode supposed to still  free float when you turn up the Phase setting?  Or can it not be phase-locked?

Title: Re: SuperSaw Unison Mode
Post by: Markus Krause on June 07, 2017, 02:01:45 PM

This behaviour is intended, since the original SuperSaw from the JP8000 is 'free running'.

Instead of this select HyperSaw as mode. Here you can use phase to trigger it.