Tone2 support forum
General Category => WarmVerb Multi-FX => Topic started by: abdull on September 17, 2013, 07:34:18 PM
-
Hello everyone
I'm trying to use warmverb as a "Send" in fl studio
But it does not work like other reverb plugins Which has wet/dry knob...
Is there a way to solve this problem?
-
Hi there. To use it as a send you want a totally wet signal. Put it in your send channel. Turn up the FX mix (to taste) in each FX slot used in Warmverb and then turn up the mix knob (top right of Warmverb gui). After that just set your mix level in FL and you're away... unless I'm misunderstanding you or missing something!?
-
Yes, this is the problem
When i put Warmverb in send channel, the sound level rises , so i have to adjust sound levels in each element all over again!
For example, ArtsAcoustic Reverb When I used it as a send, it raise the sound
But when i turn the dry knob down, it Sound right!. i do not have to adjust Anything!
-
Yes, this is the problem
When i put Warmverb in send channel, the sound level rises , so i have to adjust sound levels in each element all over again!
For example, ArtsAcoustic Reverb When I used it as a send, it raise the sound
But when i turn the dry knob down, it Sound right!. i do not have to adjust Anything!
To me, (I just tried it in Sonar to see the levels using Warmverb on a send) it seems normal since with adding an effect, it is adding more on to the sound that is already there, so the level rises a bit.
Or maybe I am way off :o