Tone2 support forum

General Category => WarmVerb Multi-FX => Topic started by: maxdamage on June 10, 2010, 10:29:58 AM

Title: Routing module
Post by: maxdamage on June 10, 2010, 10:29:58 AM

What is the purpose of the routing module with the midi sockets? It doesn't seem to do anything.

Title: Re: Routing module
Post by: Markus Krause on June 11, 2010, 09:34:32 AM

Hello Maxdamage,

the routing selects between parallel or serial processing for FX2/FX3. I recommend to set 'mix' to the maximum
value to hear the difference between the routings.

A parallel routing can be usefull if you want to combine 'reverb' + 'delay' or for special effects. The output of both effects in summed.

A serial routing is usefull for the most cases. It processes all effects in a chain. The output of the effect before is routed to the input of the next one.

Best Regards,
Markus Feil

Title: Re: Routing module
Post by: maxdamage on June 11, 2010, 01:37:52 PM

Hi Markus

Thanks for the reply. I already knew about the serial/parallel stuff. I was referring to the module to the right which is also called 'Routing'. It has 4 x audio jacks and a Midi In and Midi throu sockets. What is this section for?

Title: Re: Routing module
Post by: Markus Krause on June 13, 2010, 11:21:15 AM

Hi Maxdamage,

the lower right box is for decoration. When i designed to interface i reverved some screen space for future features. Instead of leaving a boring blank box i added some hardware-like connectors.

Best Regards,
Markus Feil

Title: Re: Routing module
Post by: maxdamage on June 13, 2010, 11:37:13 PM

I guessed as much. Extra features = The win! :)