Tone2 support forum

General Category => Saurus => Topic started by: freakyfoot on April 25, 2014, 02:41:19 PM

Title: LFO Delay
Post by: freakyfoot on April 25, 2014, 02:41:19 PM

Hello, is LFO delay possible in Saurus and if so how? Just got the plugin recently so I'm only starting to get to grips with it.

By LFO delay I mean that the LFO should fade in after holding down a key like on the original Juno synths, not with modulation/aftertouch etc

Thanks in advance

Title: Re: LFO Delay
Post by: Markus Krause on April 28, 2014, 09:34:09 AM

Fading in an LFO is possible with nearly all Tone2 synths.

For a fade-in vibrato use the following setup in the matrix:

- In matrix slot 1: Route LFO to 'fine'. Set send level to 0.
- In matrix slot 2: Route the AUX envelope to 'Matrix slot 1'. Set send level to +100.
- In the aux envelope: Set Attack to the desired value, like 2 seconds.